MIMAKI UJV55-320 - Ink Tank Warning Appears; If an Error Related to the Sub Tank Occurs (Error 618 to 61 B)

5-4
Chapter 5 Troubleshooting
Ink tank warning appears
If an ink tank trouble is detected, a warning message
appears.
None of printing, cleaning and all the other operations that
use ink is available. If an abnormality occurs, perform the
following procedures:
• Check the ink amount in the ink tank and if the ink amount
is not enough, add ink.
Displaying the description of ink bottle
trouble
The contents of ink bottle error are confirmable by the
following operations.
1
Press the key in Local.
If an error related to the Sub Tank
occurs (Error 618 to 61b)
The Error 618 to 61b are related to the sub tank.
Execute following procedures when an error about sub tank
occurs, or when the nozzle is not unclogged after cleaning.
1
Press the
(MENU)
in Local.
2
Press to select “Maintenance”,
and press the key.
• Maintenance MENU appears.
3
Press to select “Sub Tank”, and
press the key.
4
Press to select the sub tank for
maintenance, and then press ().
• Maintenance is performed only on the sub tanks
marked with “” (those selected by pressing
[FUNC2]).
• Check the test printing results ( P.2-24), and
then select the sub tanks for maintenance.
• The test printing results and the corresponding
sub tank numbers are shown below.
4-colors ink
• Test printing results and the corresponding sub
tank numbers
6-colors + White ink
• Test printing results and the corresponding sub
tank numbers
5
Press the key.
• The maintenance action selection screen appears.
6
Press the key.
• Discharge the ink in the sub tank, and charge ink
into the tank.
• When the charging into the sub tank is completed,
the air purging selection screen appears.
7
Press to select action, and press
the key.
• Select “Execute” to move to the air purge menu.
• Select “Completed” to perform head cleaning.
• Once ink tank trouble is displayed, do not leave
the ink bottle without replacing it for a long time;
otherwise, the machine will lose the nozzle
missing prevention function.
If nozzles are clogged, the machine must be
repaired by MIMAKI's service engineer.
• If you perform this setting while a sub tank-related
error occurs, the sub tank causing the error is
automatically selected. In this case, you cannot
select sub tanks by pressing [] and [].
LUS120-4
1. M 90%
EXPIRATION 2MONTH
2. C 80%
No Error
3.
Y
80%
No Error
4.
K
80%
No Error
Sub Tank
㾎Y・C
㾎M・K
㾎M・K
㾎Y・C
Sub tank 7,8
Sub tank 1,2
Sub tank 3,4
Sub tank 5,6
18432567
Sub tank
No.
㾎C・M
㾎Y・K
㾎W・W
㾎Lm・Lc
Sub Tank
Sub tank 7,8
Sub tank 1,2
Sub tank 3,4
Sub tank 5,6
18432567
Sub tank
No.