5-7
1
2
2
2
5
Chapter 5 Troubleshooting
16
Wipe ink adhering to the ink port with a
waste cloth and remove the waste cloth
covering the rail.
17
Close the maintenance cover before the
carriage and the right lower maintenance
cover of this machine. Then, press the
key.
• Cleaning starts automatically. Wait for a while until
cleaning has been completed.
18
Press the key several times to
end the setting.
When media heaves up at feeding
We call the status of heaving media at feeding “cockling”.
When media cockling occurs, check the following items:
• Wipe ink adhering to the ink port. Otherwise, it
may cause the operation defect.
Note/ checking items Measures
Checking media set status
(1) Check that the media is set straight and reset it.
Adjusting heater temperature
(1) Upper pre-heaters’ temperatures.
Media feeding
(1) For roll media, feed the media by about tens of centimeters to one
meter.
(2) For leaf media, press [][] and perform feed/ back feed.
Do not leave the media in the heater warming
status
(1) Do not start printing with the media cockled because it may cause
media jam.
Heighten the head
(1) For the thick media, make the head gap higher before printing.
To Next Page
Loading...
