5-10
Chapter 5 Troubleshooting
REFILL WATER Water in the cooling water tank is insufficient.
• Replenish the antifreeze mixed water.
(P.4-27)
WATER LACK
It has passed more than seven days after water
in the cooling water tank become low.
• Replenish the antifreeze mixed water.
(P.4-27)
While displaying this warning, you will not be
able to print.
Take-UP CoverOPEN
It was detected that the media take-up device's
cover was open.
• Close the take-up device's cover.
Take-UP WRONG
An abnormality occurred in the take-up status of
the media take-up machine.
• Check if the media setting is set to ROLL
when the take-up device is not used.
• Check if the taking-up direction switch and the
taking-up manual switch are set correctly.
( P.2-6,P.2-7)
• Check that the media is set on the media take-
up machine correctly.
• Check if the media take-up paper core is run-
ning without load.
• Turn ON and OFF the manual switch, and
raise the tension bar to a correct position.
• Feed the media in the jog operation in the
direction reverse to that used at the time when
the error occurred.
Take-UP LimitDETECT
The control limit sensor of the media take-up
machine was detected.
• Check if the media can be fed correctly in the
jog operation.
• Lower the position of the tension bar at the
take-up side.
• Even if you perform, if the same message is
displayed, contact a distributor in your district,
our office or our call center.
TAKE-UP ENC WRONG An abnormality occurred in the take-up encoder. • Turn off the main power to the machine and
turn it on after a while ( P.2-3).
Even if you perform, if the same message is
displayed, contact a distributor in your district,
our office or our call center.
Take-UP Connect The take-up unit is not correctly connected.
Take-UP Fuse Err The take-up fuse is blown.
TAKE-UP TENSION-BAR
The media set check at the start of printing
detected an abnormality of the take-up tension
bar.
• Check the media set condition and remove
any cause of the problem.
• Check that the taking-up direction switch is set
correctly. ( P.2-6)
Take-UP Voltage
An abnormality occurred in the take-up unit volt-
age.
• Turn off the main power to the machine and
turn it on after a while ( P.2-3).
Even if you perform, if the same message is
displayed, contact a distributor in your district,
our office or our call center.
Feeding CoverOPEN
It was detected that the media feeding device's
cover was open.
• Check the cover of the feeding unit.
Even if you close the cover, if the same
message is displayed, contact a
distributor in your district, our office or our
call center.
Feeding WRONG
An abnormality occurred in the feeding status of
the media feeding machine.
• Check if the media setting is set to ROLL
when the feeding device is not used.
• Check if the taking-up direction switch and the
feeding manual switch are set correctly.
• Check that the media is set on the media
feeding machine correctly.
• Check if the media feeding paper core is run-
ning without load.
• Turn ON and OFF the manual switch, and
raise the tension bar to a correct position.
• Feed the media in the jog operation in the
direction reverse to that used at the time when
the error occurred.
Message Cause Solution
To Next Page
Loading...
