MIMAKI UJV55-320 - Rear Side and Right Side of the Machine

1-4
Chapter 1 Before Use
Rear Side and Right Side of the Machine
AC inlet
Connect the power cable to the AC inlet.
Clamp lever (rear)
Interlocks with the clamp lever in
the font of this machine.
Main power switch
Turns on/off the main power for this machine.
Leave the main power turned on to prevent ink
clogging.
Roll holders
Uses when printing a media of vinyl
chloride or photo paper.
Pre-heater
Preheats the media before printing. (Located inside the cover)
Rear cover
Open the cover in setting of medias, taking of measures
against jamming of medias. Even when the power button is off,
keep this cover and the other covers closed.
Tension bar
Brings tension to the media.
Ink supply unit
Set the ink tank.
Wide media set area (2 bars)
Set a wide media.
Feweding Manual switch
Changes the feeding
method (AUTO/MANUAL).
Feeding direction switch
Changes the feeding direction
(Forward/Backward/OFF).
RS-232C connector
This is RS-232C interface
connector.
AC outlet for LED light
Connect to the outlet of the image quality
confirmation LED light.
LAN connector
This is Ethernet interface
connector.
USB 2.0 connector
This is USB2.0 interface
connector.
Power switch for LED light
Turns on/off the image quality confirmation LED
light.