2-15
2
2
2
2
23
Close the front cover.
24
Press the key to select "ROLL" .
• If the [Setting the Display of Media Detection] of
Machine Setup set in “AUTO”( P.3-16), the
machine automatically detects the media width.
25
Setting the Logical Seek.
(1) Press [][] to select the set value.
• Set value : Media/ Data/ Quality
(2) Press the [ENTER] key.
• When [Media Remain] of the Machine Setup is
"ON" ( P.3-15), you are prompted to enter the
media remaining amount. ( P.2-10)
Setting two narrow roll media
(twin rolls)
1
Set the settings of “Feeding Unit” and
“Take-up Unit” of the Machine Setup to
OFF.
• Refer to P.3-14 “Setting Feeding unit” and P.3-14
“Setting Take-up unit”.
2
Open the front cover and rearciver.
3
Rise the clamp lever.
4
Add the attached media press to hold the
two media.
(1) Remove the left side maintenance cover.
• Rotate the screws under the left side
maintenance cover (for three positions) to the
left and remove them.
• Hold the bottom of the left maintenance
cover, and pull the cover toward you from
below to remove the cover.
• If the left side maintenance cover is hard to
remove, use the supplied screwdriver.
(2) Attach the Media press in the accessories.
• Fit the protruding portion of the media press
into the groove of the platen (circle part in the
figure below).
• Before printing, rewind by hand the roll media set
on the narrow roll holder to remove any slack.
If the media is loose, the media feed amount
varies, causing poor image quality.
• When you do not use the take-up device, feed the
media until the media reaches the floor, and then
print.
If you print with the media out of contact with the
floor, the media feed amount varies during
printing, causing poor printing quality.
• Surface waviness or ruck may affect the quality of
currently printed image.
When fixing media with tape, align the media
along the direction indicated with an arrow in the
figure.
• If you pull the media too much when fixing with
tape, the media tension may not be even. And, it
may negatively affect the media feeding.
Pay attention to the following when printing on
twin rolls.
• Use media having a media width of 1524 mm or
less and a paper core width of 1550 mm or less.
• Set two media having the same properties as
shown below. Otherwise, the printed image quality
will be affected.
Media type, media grade, media width, the
diameter of media to be set (with the same
remaining media amount), and media rolling-up
direction
Screw
Left side
maintenance
cover
Rotate it left.
To Next Page
Loading...
