MIMAKI UJV55-320 - Page 57

This chapter
describes the operation procedures for using the machine more conveniently and each
setting procedure.
About Setup MENU........................................3-2
Setup MENU table ....................................... 3-3
Register the optimal print conditions to
match the use............................................... 3-4
Setting of Media Correction.......................... 3-5
If the Positions of Dots Shift... ...................... 3-6
Setting the Heater ........................................ 3-6
Setting of Logical Seek ................................ 3-7
Setting of Overprint ...................................... 3-7
Setting of Left and Right Margins................ 3-8
Setting of UV mode ...................................... 3-8
Setting of Refresh ........................................ 3-9
Setting of Vacuum Fan............................... 3-10
Setting of Print Speed ................................ 3-10
Setting of MAPS4....................................... 3-10
Setting Auto Cleaning ................................ 3-11
Setting Interval wiping ................................ 3-11
About Machine Setup MENU.......................3-12
Machine Setup MENU table....................... 3-13
Setting a AUTO Power-off.......................... 3-14
Setting Feeding unit ................................... 3-14
Setting Take-up unit ................................... 3-14
Setting the Display of Media Remain ......... 3-15
Setting Time................................................3-15
Setting Unit (Temperature/ Length) ............3-15
Setting a Key Buzzer ..................................3-15
Setting the Display of Media Detection.......3-16
Setting the CONFIRM. FEED .....................3-16
Set the network...........................................3-16
Setting event mail function..........................3-17
Setting the Setting Lock function ................3-21
Initializing the Settings................................3-21
About Nozzle Check MENU .........................3-22
Nozzle Check MENU table .........................3-22
Printing Check Flow....................................3-23
Printing Operations at “Nozzle Missing”
Judgment and Error Occurrence ................3-23
Setting the Printing Check ..........................3-24
Setting the Auto Nozzle Recoverry.............3-24
Setting the Judgement Condition................3-24
About Information MENU .............................3-25
Information MENU table .............................3-25
Displaying the Information ..........................3-26
Displaying the Information of this machine .3-26
Setting a Language ......................................3-27
Chapter 3
Extended Functions