MIMAKI UJV55-320 - Setting Auto Cleaning; Setting Interval Wiping

3-11
Chapter 3 Setup
3
2
2
9
Press to change the smoothing
level, and press the key.
• Set Value : 0 to 100% (set in units of 5%)
• The MAPS4 effect become strong as the set value
increase, and become weak as the set value decrease.
• When use a white ink, set both the smoothing
level for the color ink and white ink.
10
Press the key several times to
end the setting.
Setting Auto Cleaning
You can set the machine so that it counts the number of
printed files or the length or time has been completed, and
performs cleaning automatically if required.
You can select the auto cleaning setting from three types
below:
• File : Set the cleaning intervals by the number of
printed files.
• Length : Set the cleaning intervals by the printed
length.
• Time : Set the cleaning intervals by the printed time.
The machine can perform a stable printing operation with
its heads always kept clean.
1
Press the
(MENU)
key in
Local.
2
Press to select SETUP 1 to 4, and
press the key.
• Setup menu appears.
3
Press the
(<<)
.
4
Press to select “AUTO CLEANING”
, and press the key.
5
Press to select the type of auto
cleaning, and press the key.
•
There are “File”, “Length” and “Time” for auto
cleaning.
File : When the set files has been completed,
the machine performs head cleaning
automatically.
Length : When the set length has passed, the
machine performs head cleaning
automatically.
Time : When the set time has passed, the
machine performs head cleaning
automatically.
• If you do not set auto cleaning, first select “OFF”
and then proceed to the Step 7.
6
Press to select the "Interval”,
and press the key.
• Depending on the auto cleaning type selected in
the Step 3, the setting value differs.
For File : 1 to 1000 File
For Length : 0.1 to 100.0m
(in 0.1m increment)
For Time : 10 to 100min (in 10min increment)
7
Press to select the “Type” and
then press the key.
• Set Value : Normal/ Soft/Hard
8
Press the key several times to
end the setting.
Setting Interval wiping
When a set time has elapsed, the machine automatically
wipes the nozzle surfaces of the head to remove any ink
droplets attached to the surfaces.
In case that deflection, nozzle missing, or symptom which
ink droplets fall down occurred, set the interval between
each operation shorter.
1
Press the
(MENU)
key in
Local.
2
Press to select SETUP 1 to 4, and
press the key.
• Setup menu appears.
3
Press the
(<<)
.
4
Press to select “Interval Wiping”
, and press the key.
5
Press to set intervals.
• Set Value : 3 to 255 Minutes, OFF
• When [OFF] is set, periodical wiping is not
executed.
6
Press the key.
7
Press the key several times to
end the setting.
• The color tone may change, depending on the
timing when auto cleaning is performed. Check in
advance that the color tone is not affected.
• Depending on the state of the heads, etc., the
image quality deterioration may not be improved
even with this function performed.In this case,
contact our service office or the distributor in your
region.
• The color tone may change, depending on the
timing when periodic wiping is performed. Check
in advance that the color tone is not affected.