MIMAKI UJV55-320 - Setting Event Mail Function

3-17
3
2
2
11
Press to select the set
values.
12
Press to confirm the value.
13
Press the key several times to
end the setting.
Setting event mail function
Set the function to send e-mails to the set e-mail address
when events such as cutting start/ end and stop due to an
error.
You can also perform event mail function setting with
“Network Configurator”, the tool to perform network
setting of Mimaki’s product. To download the Network
Configurator, check " Driver / Utility" on the download
page at Mimaki Engineering (http://eng.mimaki.co.jp/
download/).
Enable the event mail function
1
Press the
(MENU)
in Local.
2
Press to select “Machine Setup”
and press the key.
3
Press the
(<<)
.
4
Press to select “Network & Mail”
and press the key.
5
Press to select “Event Mail” and
press the key.
6
Press to select “Mail Deliverry”
and press the key.
7
Press to select “ON” and press
the key.
8
Press the key several times to
end the setting.
• To reflect network setting, once turn off the power
supply and then turn it on again.
Disclaimer
• The customer is responsible for the communication fee for
Internet communication such as e-mail notification.
• The notification by the event mail function may not be
delivered due to Internet environment, failure of the device/
the power supply, etc. Mimaki has absolutely no
responsibility for any damages or loss resulting from non-
delivery or delays.
• You can use event mail function by connecting
LAN to this machine. Please prepare for LAN
cable connection beforehand.
• Not compatible with SSL communication.