4-11
4
2
Chapter 4 Maintenance
6
Clean the cap rubber and cap rubber cover
and press the key.
• Wipe off the ink sticking to the cap rubber and cap
rubber cover with a clean stick dipped in cleaning
solution for maintenance. Wipe off so that
cleaning solution for maintenance will not remain.
• At this time, the discharge passage is cleaned
automatically.
7
Fill up the cap with cleaning solution for
maintenance, using a dropper.
• Fill the cap with the cleaning solution just before
the solution overflows from the cap.
8
Close the right maintenance cover,
and press the key.
• The nozzles are washed.
• When the nozzles have been completely washed,
the head moves onto the platen.
9
Suction the cleaning solution into a
syringe and squirt about three syringes
worth of solution into each cap.
10
Close the right side maintenance cover
and press the key.
• After the idle absorbing operation has been
performed for 30 seconds, the screen returns to
step2.
• Until washing liquid is filled, [Fill the liquid.] is
displayed on the screen.
Cap rubber Cap rubber cover
To Next Page
Loading...
