Using the QC Programs
8-3
Editing QC settings
If there are saved QC results and settings, you need to delete them first. You can press [F5]
to enter “QC Table” screen to delete all the results, see Chapter 8.2.3 for details.
Entering the “QC Edit” screen
Press [F3] at “Controls” screen to enter the “QC Edit” screen (Figure 8-3).
Figure 8-3 “QC Edit” screen
Entering lot number
ENTER the lot number of the control to be used into the “Lot No.” box, as Figure 8-4 shows.
Figure 8-4 Entering lot number
Entering expiration date
ENTER the expiration date of the control to be used into the “Exp. Date” box, as Figure 8-5
To Next Page
Loading...
