Mindray BC-2800 - Chapter 4 Histograms and Pulse Graphs

Installing Your Analyzer
4-7
Figure 4-3 Rinse container
2. Take out the rinse container and place it on or below the countertop;
3. Remove the container cap and insert the tube end that has no connector into the rinse
container and tighten the cap until properly secured, as Figure 4-4 shows;
Figure 4-4 Insert the tube end into the container
4. Locate the blue fitting marked “RINSE” in the lower right corner of the back of the
analyzer.
5. Plug the blue connector of the tube into the fitting and turn it clockwise until properly
secured.
Connecting the lyse container
1. Take out the lyse pickup tube (the one with an orange connector) from the accessory box,
as Figure 4-5 shows;