Customizing the Analyzer Software
5-24
3) how many WB samples had been run after probe wipe cleaning.
For more information about auto maintain, see Chapter 10 Maintaining Your Analyzer for
detail.
Change the WB samples can be run between two cleanings
1. Enter the administrator password as introduced in Chapter 5.2.1.
2. At the “Settings” screen, press [F1] to select the “Auto Maintain” group, as Figure 5-39
shows.
3. ENTER the desired digits.
Figure 5-39 Auto maintain screen(2)
Exiting the “Auto Maintain” group
When you have finished the changing, you may
1. Press [F1] to select another setting group you want to change; or;
2. Press [MENU] and a message box will pop up to remind you to save the changes, as
Figure 5-40 shows. CLICK “Yes” to save the changes and exit to the system menu; or
CLICK “No” to exit to the system menu without saving the changes.
Figure 5-40 Saving changes
To Next Page
Loading...
