8 - 6
You can change the concentration parameters (Drug Amt., Volume or Conc.) as
needed. See 11 Password Protected Settings.
You can change the units of drug amount, dose rate, and concentration before starting
an infusion or when the infusion is paused. To do so, select the corresponding unit of
Drug Amt., Dose Rate or Conc., and reconfigure in the popup dialog.
• In the dose time mode, the supported dose rate units are X/min, X/h, and X/
24h, in which X represents ng, ug, mg, g, mU, U, kU, EU, mmol, mol, mcal, cal,
kcal, and mEq.
• Rate and time can only be obtained by calculation. They are not available for
manual input.
To Next Page
Loading...
