3-6
NOTE
Compatible power supply: 100–240V
, 50/60Hz.
The AC power cable should be correctly inserted and secured into the
socket.
Removing power cord is to disconnect equipment from power supply.
Please ensure suitable clearance around the device to facilitate connect
and remove power cord.
3.1.7 Install and Operate the Drop Sensor (Optional)
NOTE
This section should be used with the optional drop sensor. The user may
skip the instructions in this section if a drop sensor is not included with the
infusion pump.
1. Firmly insert the signal line of drop sensor into the drop sensor interface of the
pump.
2. Clip the drop sensor to the drip chamber, making sure that the drop sensor is
above the surface of the liquid.
3. Press to start the infusion. The light of drop sensor flashes green when
liquid is detected in normal infusion status.
To Next Page
Loading...
