Mindray Consona N9 Exp - Smart FLC (Smart Follicles Calculation); Basic Procedures for Smart FLC

7 - 38 Operator’s Manual
7 3D/4D
– Tap [Current Plane] to reset the plane. The position of the current plane returns to the
initial condition. The angle of the current plane returns to 0°.
– Tap [Current Plane] to reset the current plane. The position and the angle to the current
plane returns to the last MSP condition.
Other related Operations
• Hiding the reference
Tap to hide or show the reference line.
• Hiding the measurement
Tap to hide or show the measurement.
• Switching between the single and quad-split display
Tap [Single]or [Quad] between the single and quad-split display.
7.16 Smart FLC (Smart Follicles Calculation)
CAUTION
• Smart FLC result is provided for reference only, not for confirming a
diagnosis.
• Smart FLC is not available in Smart 3D mode.
7.16.1 Basic Procedures for Smart FLC
Perform the following procedure:
1. Acquire necessary 3D/4D data and freeze.
2. Tap [Smart FLC] tab to enter Smart FLC, and the system is in the “Edit ROI” status ([Edit
ROI] button is highlighted).
3. Set the position and size of the ROI box.
4. Tap [Calc] on the touch screen.
5. Auto calculation is finished:
– Section image (A, B, C) is enclosed with colored lines and the color corresponds to the
follicle in VR window.
– 3D image (VR);
– Results on the right of the screen are displayed in a table.
V: Volume
d1, d2, d3: diameters of the follicle
MD: Follicle Diam
NOTE:
To ensure the correctness of the results, please select an image with clear follicle boundary when
entering smart FLC.