Mindray Consona N9 Exp - Smart Scene 3 D

7 - 40 Operator’s Manual
7 3D/4D
Tap [Face+] to select the levels between 0-3.
Eraser
NOTE:
This function is available only under “Surface” mode.
Clearing effect in the center of the eraser sphere is strongest, and this effect weakens along the
sphere center to the edge.
Tap [For-Rubber] to erase existing data on the screen.
Tap [Re-Rubber] to restore those removed shading data.
• Use [EraseSize] to select the size: Small, Middle, Large.
• Tap [Undo] to undo the operation in sequence and tap [Undo All] to undo all erase effects.
AutoDirect
This feature allow you to optimize to a best observing angle of view within one step.
The recommended angle: fetal head is facing up and the face is at the front with [Direction] to be
up/down.
FaceContact
The higher the value, the more adjacent the VR image is to the fetal face, and the more obstacles
cleared.
The lower the value, the further the VR image is to the fetal face, and the less obstacles cleared.
Select [FaceContact] to adjust the parameter.
7.18 Smart Scene 3D
NOTE:
• Smart Scene 3D is not available in Smart 3D mode.
• This feature is available only under GYN, OB2 or OB3 exam mode.
In 3D/4D acquisition preparation status, this feature can adjust ROI size and position automatically
and activate appropriate render modes according to the recognized anatomical structure of some
organs.
For OB2/OB3 exam mode, spine, brain, long bone and face can be recognized. For GYN exam
mode, endometrium can be recognized.
Perform the following procedure:
1. Enter 3D/4D acquisition preparation status.
2. Tap [Smart Scene 3D] under 3D/4D Scenario Setting to enable the feature.
– If necessary, select the desired organ type manually.
– If necessary, tap [Refresh] to reset the ROI.
– If necessary, adjust the ROI size and position manually.
3. Press <Update> to begin 3D/4D acquisition.