17 Probes and Biopsy
Operator’s Manual 17 - 25
b. Separate the residual part of the needle-guide bracket and the probe from the needle.
c. Remove the support of needle-guided bracket from the probe.
NGB-007 Metal/needle detachable needle-guided bracket
Perform the following procedure:
1. Install the needle-guided bracket:
a. Put on the sterile probe sheath.
1 Support for needle-guided bracket 2 Tab and groove for the needle-guided
bracket
3 Angle-adjusting base 4 Angle shift sign
5 Angle pinch nut 6 Angle block
7 Guiding block 8 Guiding block specification
9 Needle guide hole 10 Needle-guided bracket pinch nut
To Next Page
Loading...
