17 - 30 Operator’s Manual
17 Probes and Biopsy
Perform the following procedure:
1. Install the needle-guided bracket:
a. Put on the probe cover.
b. Cover the support of needle-guided bracket on the probe, making the groove of the
needle-guided bracket to match with the tab of the probe. Set the needle-guided bracket at
the desired position, turn tightly the knob of fixing needle-guided bracket to fix the
needle-guided bracket.
c. Select a proper guiding block and thread the knob of fixing the guiding block through the
hole of installing guiding block, move the guiding block to the desired position, then turn
tightly the knob of fixing the guiding block to fix the guiding block on the support of
needle-guided bracket.
4. Knob of fixing needle-
guided bracket
Used for fixing the needle-guided bracket on the probe
5. Needle distance scales Indicate distance between needle and the probe head surface
6. Guiding block Used for installing biopsy needle; there are five specifications
of guiding blocks for different needles
7. Knob of fixing the needle Used for fixing the needle
8. Guiding hole of the
needle
Used for installing the biopsy needle
9. Specification of guiding
block
Matched with the corresponding biopsy needle
10. Mark of indicating scales Indicating needle distance scales
11. Knob of fixing the
guiding block
Used for fixing the guiding block
No. Name Description
To Next Page
Loading...
