17 Probes and Biopsy
Operator’s Manual 17 - 31
d. Insert a biopsy needle with the same specification as that of the guiding block into the
hole of the guiding block and turn tightly the knob of fixing the needle.
2. Remove the needle-guided bracket:
a. Turn on the knob of fixing the needle and separate the needle from the needle-guided
bracket.
b. Turn on the knob of fixing guiding block and remove the guiding block from the hole of
installing guiding block.
c. Turn on the knob of fixing needle-guided bracket and remove the needle-guided bracket.
NGB-010
Perform the following procedure:
1. Install the needle-guided bracket:
a. Put on the sterile probe sheath.
1 Guiding block 2 Guiding hole of the biopsy needle
3 Support of needle-guided bracket 4 Knob of fixing needle-guided bracket
5 Grooves of the needle-guided bracket 6 Needle guide angle
7 Knob of fixing the guiding block 8 Specification of guiding block
To Next Page
Loading...
