17 Probes and Biopsy
Operator’s Manual 17 - 39
Perform the following procedure:
1. Install the needle-guided bracket:
a. Put on the sterile probe sheath.
b. Open the clamp. Insert the front clamp to the front groove.
c. Push the biopsy forward (arrow’s direction) until the locating pole inserting into the
location hole. Turn the lower clamp against the intra-cavity probe. Tighten the nut to lock
the biopsy (arrow's direction).
2. Remove the needle-guided bracket:
Hold the prober in the left hand; unscrew the locking nut with the right hand to loose the
clamp (arrow’s direction).Lift the biopsy up (towards arrow’s direction). The locating
pole, front clamp, the locating hole and the front clamp become loose.
7 Front slot 8 Positioning block
1 Align the front clamp with the front slot.
To Next Page
Loading...
