4 - 20 Operator’s Manual
4 Setup
5. Click [Complete] to finish setting. The user-defined measurement item is listed in the
“Selected Items” menu and in the “User-defined” category of “Available Items”. An asterisk
appears after the user-defined item for identification.
The user-defined measurement item will be added automatically to the “Selected Items” in the
Report template. If the item is completed in an exam, the results will be displayed in the report.
User-defined Calculations
• Please ensure the correctness and validity of the defined formula, otherwise Mindray will not
be liable for damage caused by improper definition of the formula.
• Trigonometric functions are in degrees, not radians.
• PI is accurate to 7 digits.
User-defined calculations are derived from arithmetic operations in which the parameters are
measurement, calculation or study results obtained in measurement items which exist in the system
or are user-defined.
Perform the following procedure:
1. Select the [Measure] tab page.
2. Click [New].
The “Measurement Custom Wizard” dialog box appears.
3. Enter the Name in the “Measurement Custom Wizard” dialog box, select “Add Calc”, then
select [Next].
Measurement Result Choose the results to be displayed in the results window. The result name
can be changed.
Move the cursor over an item and press <Set>, then enter the name in the
text box.
Unit Select the measurement unit.
Click “Unit” column of each item to select.
Attributes Descriptions
To Next Page
Loading...
