7 3D/4D
Operator’s Manual 7 - 31
After
Hide/show reference image
The system displays 3 standard sectional images (A plane, B plane, C plane) on the left
side indicating the position of the slice lines; tap to hide the 3 reference images,
and then slices are displayed on the whole image area.
Quick switch to single display
Select a certain slice, double click <Set> to see the slice full screen, and double click
<Set> again to return to the original display format.
Reset Ori.
Tap [Reset Ori.] to reset the orientation and zoom status of the image.
7.14 SCV
+
SCV
+
is SCV (Slice Contrast View) +CMPR (Curved MPR).
SCV imaging can reduce speckle noise and improve contrast resolution as well as enhance signal-
noise ratio, which helps in discovering diffuse pathology in organs.
The curved MPR function allows straightening of a curved surface/anatomy. In clinical application,
this is usually used for imaging fetal spine.
SCV
+
imaging is not available in Smart 3D mode.
7.14.1 Basic Procedures
SCV operation
Perform the following procedure:
1. Acquire necessary 3D/4D data.
2. Tap [SCV
+
] tab on the touch screen to enter SCV imaging, and the system displays three
section images in A, B and C window.
To Next Page
Loading...
