Mindray Consona N9 - Moving Comments; Editing Comments

14 Measurement, Comments and Body Mark
Operator’s Manual 14 - 5
Using the control panel:
1. Use the trackball to move the cursor to a desired position, and press <Set> to confirm the start
point.
2. Use the trackball to move the cursor along the edge of the desired region and trace the outline
of the region.
– Rotate the <Angle> knob counter-clockwise to cancel 1 pixel of trace.
– Rotate the <Angle> knob clockwise to restore 1 pixel of trace.
– Short press <Clear> to clear last trace. Long press <Clear> to delete all tracing.
3. Press <Set> to finish the tracing.
Using the touch screen:
1. Trace around the ROI by taping the touch screen image using your finger.
2. Remove your finger to finish the tracing.
– [Clear]: tap to delete the trace in reverse order one by one.
– [Clear All]: tap to delete all traces.
3. Tap [Exit] to exit the tracing.
14.2.3 Moving Comments
NOTE:
If image size and position changed due to display format switching, then the position of the
comment can be changed, too.
Perform the following procedure:
1. Select the comment to be moved.
2. Use the trackball to move the comment to the new position.
3. Press <Set> to anchor the comment in the new position, and the comment-moving operation is
complete.
14.2.4 Editing Comments
Modifying characters
Perform the following procedure:
1. In comment status, move the cursor onto the comments to be modified.
– Press alphabetic keys to enter the character to the cursor position directly.
– Or, double press <Set> to enter comment editing status, and use the direction-control keys
to move the cursor to the desired location to insert/delete characters; you can either type
characters by pressing the corresponding keys or select the new comment text from the
menu.
2. Press <Del> on the keyboard to delete the comment character or text on the right side of the
cursor; press to delete the comment character or text on the left side of the cursor.
3. Press <Set>, or move the cursor to confirm the added comments text and exit the edit status.
If there are already comments on the screen, press the space bar to enter editing status.
Modifying Arrows
Perform the following procedure: