5-38 Image Optimization
To undo the last cutting, select [Undo] on the soft menu.
To undo all cuttings, select [Undo All].
The image cutting parameters are described as follows:
Allows you to trace the portion of the image you want to cut.
Displays a box which can be used to define the portion of the
image you want to cut.
To undo the last cut only.
To undo all cuts since you entered image edit mode.
Section image (MPR) measurement.
2D related measurements can be performed on MPR. For details, see [Advanced Volume].
Measurement is not available in acquisition preparation status.
5.10.3.4 Image Saving and Reviewing in Smart 3D
Image saving
In 3D viewing mode, press the single image Save key (Save Image) to save the
current image to the animal information management system in the set format and
image size.
Save clip: in 3D viewing mode, press the user-defined Save key (Save Cine
(Retrospective)) to save a CIN-format clip to the hard drive.
Image review
Open an image file to enter the image review mode. In this mode, you can perform the
same operations as in VR viewing mode.
To Next Page
Loading...