11
IV. Troubleshooting
Problem Possible cause Possible solution
Dishwasher will not
start
Dishwasher not receiving electrical
power
Door is unlatched
Dishwasher not level
Check electrical connection
fuse/circuit breaker
Close and latch door
Level unit
Dishes not clean Improper loading
Spray arm not rotating freely
Not enough detergent and/or
improper detergent being used
Improper prepared dishes
Water inlet hose kinked/bent due to
improper installation
Arrange dishes so spray
action reaches all surfaces
Do not overload dishwasher
Check spray arm to make
sure nothing is obstructing
spray arm rotation
Check if filter screen has
become dislodged and
obstructing spray arm
rotation
Use more dishwasher
detergent
Do not use detergent that is
hard or cracked
Excess food soil and liquids
should be removed from
dishes before loading
Eliminate kink or bend from
inlet hose
Chipping or
breaking glassware
Improper loading of dishes Do not overload dish rack
Load glasses on the upper
rack only
Water remains in
bottom
A small amount of water (in pump
area) is normal
Excessive amount of water, cycle not
completed
This is necessary to keep
the pump primed
Allow dishwasher to
complete full cycle
Voltage
230 Volts – 50Hz
The manufacturer reserves the right to modify the design features of the products to
improve quality of it.
To Next Page
Loading...