Minebea Intec ISEDE-16-34-64-H - Detailed Specification Tables by Block

ISEDE-models16-HCE34-HCE64-SCE
Initial zero point range
(kg)
111,3
Zero point range of max.
load (+/- %)
222
Repeatability (≤ ± g)
((standard deviation))
0,050,070,3
Linearity deviation (≤ ± g)0,20,20,5
Measuring time (typically
in s)
<1,5<1,5<1,5
Shortest measuring time
(s)
<1<1<0,8
Customization to opera-
ting and setup conditions
4 optimized lter levels4 optimized lter levels4 optimized lter levels
WM1 0,05s-0,01s (100 Hz)WM2 0,1sWM4 0,4sData output sequence (de-
pending on set installation
location)
Data output with menu code 1-14-7
IP protectionIP65IP65IP65
Storage temperature ran-
ge (°C)
-10 … +40
Maximum overload capa-
city (kg)
130130130
Data interfaceRS485, cable with 12-pin
round connection plug,
3 m, optional RS232
RS485, cable with 12-pin
round connection plug,
3 m, optional RS232
RS485, cable with 12-pin
round connection plug,
3 m, optional RS232
Power supply15 VDC max. 2W15 VDC max. 2W15 VDC max. 2W
Warm-up time (h)000
Net weight (approx. kg)161616
Power consumption VA
(weighing platform only)
typical 2,5typical 2,5typical 2,5
6.3Specication tables
The conguration menu of a control unit is used to set the respective specication variant.
ISEDE-16-H(V1): Block 1 bis 6
Specication blockSp. block 1*Sp. block 2Sp. block 3Sp. block 4Sp. block 5Sp. block 6
Select with menu code:10 3 110 3 210 3 310 3 410 3 510 3 6
Max. load (kg)1663121612
Readability (g)0,10,10,10,50…6 kg: 0,1
6…16 kg: 1
0…6 kg: 0,1
6…12 kg: 1
6 SpecicationsISEDE‑16‑34‑64‑H(V1) | ISEDE‑16‑34‑HCE | ISEDE‑64‑S(V1) | ISEDE‑64‑SCE
EN-21Minebea Intec