Minebea Intec PR 1626/60 - Device Installation; Mounting Options

5 Installation
5.1 Mounting
Note:
The device is supplied already congured. It is not necessary to open the device.
Before mounting, the instructions in chapter 2.4 have to be observed. The instrument is
suitable for mounting in any position. It can
- either be mounted by means of two screws,
- or be xed to a 35 mm rail (acc. to EN 60715).
Dimensions
dimensions in mm (see also Chapter 8.7)
Intrinsically safe load Cell interfaces PR 1626/60, ../61 5 Installation
EN-10 Minebea Intec