Minebea Intec PR 1626/60 - Safety Guidelines; General Safety Notes; Intended Use and Personnel; Pre-Operation Inspection

2 Safety instructions
2.1 General notes
NOTICE
Warning of damage to property and/or the environment.
The product was in perfect condition with regard to safety features when it left the
factory.
To maintain this condition and to ensure safe operation, the user must follow the
instructions and observe the warnings in this manual.
2.2 Intended use
The device PR 1626/60, ../61 is intended for the intrinsically safe separation of electrical
devices which are located in an area prone to explosions and electrical devices located in
a secure area.
Product operation, commissioning and maintenance must be performed by trained and
qualied personnel who are aware of and able to deal with the related hazards and take
suitable measures for self-protection.
The device reects the state of the art.
No warranty is given that the product is free of faults, especially not in conjunction with
third-party software and hardware components required for operation.
The manufacturer does not accept any liability for damage caused by third-party system
components or due to incorrect use of the product. The use of this product signies
recognition of the stipulations listed above.
2.3 Initial inspection
Check the contents of the consignment for completeness, see Chapter 4. Check the
contents visually to determine whether any damage has occurred during transport. If
there are grounds for rejection of the goods, a claim must be led with the carrier
immediately. The Minebea Intec sales or service organization must also be notied.
2.4 Before operational startup
NOTICE
Perform visual inspection.
Before operational startup as well as after storage or transport, inspect the device
visually for signs of mechanical damage.
Before operational startup, acceptance of the installation by an authorized expert is
compulsory.
Mounting, installation, and earthing
When installing and assembling the device, the information in the EU type examination
certicate and the respective national regulations for the installation of electrical systems
in potentially explosive atmospheres must always be observed (in Germany in accordance
with VDE 0165, for example).
2 Safety instructions Intrinsically safe load Cell interfaces PR 1626/60, ../61
Minebea Intec EN-5