Minebea Intec PR 5230 - Serial Ports Parameter; Date & Time; Operating Parameter

— Printer Printer
Selection: <none>, built-in RS232, built-in
RS-485
— Param Selection: Assigned to, protocol, Baudrate, Bits,
Parity, Stopbits, Output mode
— Cong See Menu [Printing parameter].
— Remote display Remote display
Selection: <none>, built-in RS232, built-in
RS-485
— Param Selection: Assigned to, Baudrate, Bits, Parity,
Stopbits, Mode
— ModBus RTU Selection: <none>, built-in RS232, built-in
RS-485
— Param Selection: Assigned to, Baudrate, Bits, Parity,
Stop bits, Slave-ID
— SMA Selection: <none>, built-in RS232, built-in
RS-485
— Param Selection: Assigned to, Baudrate, Bits, Parity,
Stopbits
— xBPI-Port Selection: <none>, built-in RS232, built-in
RS-485
— Param Selection: Assigned to, Baudrate, Bits, Parity,
Stopbits
— EW-Com Selection: <none>, built-in RS-485
— Param Selection: Assigned to, Baudrate, Bits, Parity,
Stopbits, Slave-ID
— Date Date
Input: yyyy, mm, dd
— Time Time
Input: hh, mm, ss
— Application Selection: Standard, EasyFill
— Address Device address, e.g. for the printout
Input: AZ
— PIN Access code, to protect the system setup from
unauthorized operation.
Input: 6 numerical characters
— Sequence number Automatic counter for print jobs
— SetTareKey Tare key
Selection: Tare&reset tare, tare&tare again,
disabled
— SetZeroKey Zero-setting key
Selection: only when not tared, reset tare on
zeroset, disabled.
7.11.1 Serial ports parameter
7.11.2 Date & time
7.11.3 Operating parameter
7 Commissioning Transmitter in eld housing PR 5230
EN-115 Minebea Intec