Minebea Intec PR 5230 - Printing Parameter; Fieldbus Parameter; Network Parameter; Weighing Points

— Printing mode Printing mode
Selection: Triggered (trigger one printout),
Cyclic, Cyclic with enable
— Printing interval Printing interval
This menu item only appears if the [Cyclic] or
[Cyclic with enable] printing mode has been
selected.
Input: 1250
— Printing interval unit Unit of the printing interval
Selection: Seconds, Minutes, Hours, Meas. time
— Printlayout Item 16 Print layout for line 16; see Chapter 7.15.4.
— Fieldbus protocol Fieldbus protocol, display: Only if PR 1721/4x is
installed in slot 2, see Chapter 7.15.5.
— HW address MAC-ID, display: e.g.: 00:90:6C:31:1F:55
— Hostname
Unique device name, input: 224
alphanumerical characters
— Use DHCP Check the ☑ box to activate DHCP.
— IP address IP address, display: network address assigned
by the server
— Subnet mask Subnet mask, display: Mask for valid IP address
range
— Default gateway Standard gateway, display: IP number for
gateway
— Remote access Remote access to VNC client
— VNC client Access restriction, Input: authorized client for
instrument operation
— Weighing point A Selection: Internal A, xBPI-scale, Pendeo Load
Cells
— Calib Calibration, selected "Internal A:" New, Modify,
Param, see Chapter 7.11.7.1.
— Setup Setup, "xBPI-Scale" selected: Calibration,
Conguration, Select, Show device info, see
Chapter 7.11.7.2.
— Cong Conguration, "xBPI-Scale" selected: Type,
W&M, Tare timeout, Serial number, SBN
Address, see Chapter 7.11.7.2.
7.11.4 Printing parameter
Note:
This menu item is only available if under -[Operating parameter]- [Application]
"Standard" has been selected.
7.11.5 Fieldbus parameter
7.11.6 Network parameter
7.11.7 Weighing points
Transmitter in eld housing PR 5230 7 Commissioning
Minebea Intec EN-116