Minebea Intec PR 5230 - Limit Parameter; Digital I;O Parameters; Analog Output Parameter

— Limit 13 on
Enter 0 – Max (maximum load); take unit from
calibration.
— Action
Action, selection: no action, set marker 13, clr
(clear) marker 13
— Condition Condition, selection: see Chapter 7.15.8.
— Limit 13 o
Enter 0 – Max (maximum load); take unit from
calibration.
— Action
Action, selection: no action, set marker 13, clr
(clear) marker 13
— Condition Condition, selection: see Chapter 7.15.8.
— Output 1…3 Congure outputs, selection: see
Chapter 7.15.10.
— Input 1…3 on Congure inputs
— Action Action, selection: see Chapter 7.15.9.1.
— Condition Condition, selection: see Chapter 7.15.9.2.
— Input 1…3 o Congure inputs
— Action Action, selection: see Chapter 7.15.9.1.
— Condition Condition, selection: see Chapter 7.15.9.2.
— Analog mode Analog output parameter: Gross D08 = gross,
Net if tared D09 = Net if tared, Selected D11 =
value on the display, Transparent D30 =
Transparent, no output = analog output
unused, see Chapter 7.15.12.
— Analog range
Output range: 020 mA, <420 mA>
— Output on error Output on error: 0 mA = set to 0 mA, <4 mA> =
set to 4 mA, 20 mA = set to 20 mA, hold = last
output value remains unchanged
— Output if <0 Output if <0: set 0 mA = 0 mA, set <4 mA> =
4 mA, set 20 mA = 20 mA, linear = goes below
4 mA down to the limit (with 420 mA)
— Output if >Max
7.11.9 Limit parameter
Note:
This menu item is only available if under -[Operating parameter]- [Application]
"Standard" has been selected.
7.11.10 Digital I/O parameters
Note:
This menu item is only available if under -[Operating parameter]- [Application]
"Standard" has been selected.
7.11.11 Analog output parameter
7 Commissioning Transmitter in eld housing PR 5230
EN-123 Minebea Intec