Minebea Intec PR 5230 - Xbpi-Parameter Tables

— Ambient conditions
— Very stable cond.
— Stable conditions
— Unstable cond.
— Very unstable cond.
— Application/Filter
— standard mode
— manual lling
— automatic dosing
— checkweighing
— Stability range
— 0.25 digit
— 0.5 digit
— 1 digit
— 2 digits
The parameters are listed as an overview in the following, see Chapter 7.13.5.2.
Note:
Only the parameters supported by the connected scale are displayed.
Press [No] for exit from the menu without data change.
The parameters are listed as an overview in the following, see Chapter 7.13.5.3.
Note:
Only the parameters supported by the connected scale are displayed.
Press [No] for exit from the menu without data change.
7.13.5 xBPI-parameter tables
The parameters which must be entered are listed in the following tables under [Weighing
point]- [Weighing point A]- [xBPI-Scale]- [Setup]- [Conguration]- [Weighing
parameters]/[Application settings]/[Interface settings].
7.13.5.1 Scale parameters
[Weighing parameters]
14. Select [Application settings] with the cursor and conrm.
15. Press the softkey to exit the menu and to save the settings.
A prompt window opens.
16. Press the [Yes] softkey to save the data.
17. Select [Interface settings] with the cursor and conrm.
18. Press the softkey to exit the menu and to save the settings.
A prompt window opens.
19. Press the [Yes] softkey to save the data.
7 Commissioning Transmitter in eld housing PR 5230
EN-153 Minebea Intec