Minebea Intec PR 5230 - Configuring Digital Inputs

7.15.8.4 Saving parameters
7.15.9 Conguring digital inputs
An action both for signal change from 0 to 1 (on) and from 1 to 0 (o) can be determined
for each of the three inputs.
Digital inputs can be linked with conditions that must be met before an action can be
started.
The parameters for the digital inputs are dened under -[Digital i/o parameter].
Note:
This menu item is only available if under -[Operating parameter]- [Application]
"Standard" has been selected.
For the conguration the following order must be followed:
1. Dening an action
2. Determining a condition
3. Saving parameters
2. Select and conrm the appropriate line (here: Standstill is active).
3. If applicable, select additional conditions for the other limits and conrm.
Press the softkey to exit the menu.
7 Commissioning Transmitter in eld housing PR 5230
EN-201 Minebea Intec