Minebea Intec PR5900 - Update Software

6.9.2 Update software
In this menu item (under Update software), the software on the device is replaced with
the latest software.
The software can be updated from an attached storage medium or a shared directory:
- [SD card], see Chapter 6.9.2.1.
- [SD card (factory data)], see Chapter 6.9.2.2.
- [USB stick], see Chapter 6.9.2.3.
- Shared directory (Network share connections), see Chapter 6.9.2.4.
Note:
The connections with the shared directories are only shown if this has been congured
in the menu [Operating]- [System setup]- [Network share connections] .
Accessible via MENU - [Operating]- [System maintenance]- [Update software]- [Update
software] .
Update software @admin
Update software
Update via FlashIt!
Update software for remote terminal
Remove application
Restore software from SD card
The software is loaded onto the device. The device runs a cold start. The database
is restored from the temporary backup.
Select and conrm [Update software].
Select media for update software
Attached storage devices
SD card
SD card (factory data)
USB stick
Network share connections
Alibi
Backups
Exports
ONECLICKUPDATE
Reports
Software
The window listing the available storage media is shown.
6 System maintenance Process Controller Maxxis 5 PR 5900
EN-317 Minebea Intec