Minebea Intec PR5900 - Page 69

4.1.4.3 Network share connection
In this menu item (under Printer), the parameters for a shared directory (network share
connection) as a printer are congured.
Accessible via MENU - [Operating]- [System setup]- [Connected devices]- [Printer]-
[Interface]- [Network share connection] .
Printer @admin
Interface not assigned
Test print Save
Not assigned
Built-in RS-232
Built-in RS-485
Option-2 RS-485-A
Option-2 RS-485-B
Network printer
Network share connection
USB printer
USB folder
Printer @admin
Interface
Printer type
Connection name
Network share connection
CR/LF translation
Reports
Default Test print Save
[Printer type]
The choice depends on the processing of the print le: raw, CR/LF translation, EPSON
TM‑U220, EPSON LQ-300K, Generic PCL5 (Unicode), Generic PCL5 (codepage),
Generic ESC/P2
[Connection name]
Save location of the print le. At least one network share connection must be
available; see Chapter 4.5.
1. Select and conrm [Network share connection].
A selection window opens.
2. Select and conrm the individual parameters.
3. Press the [Test print] soft key.
A test page (see Chapter 10.2) is printed.
4. Check the printer settings and change if necessary.
5. Press the [Save] soft key to save the settings.
4 System setup Process Controller Maxxis 5 PR 5900
EN-67 Minebea Intec