106
7−17. Check mode
The following confirmations can be made in the Check mode.
・Check on ROM version
・Check on the option installed.
・Check on bridge voltage
・Check on the external control input
・Check on the open collector output
・Check on the analog output(option)
・Check on the BCD output (option)
● The confirmation of the analog output can operates only when analog
output is installed.
● The check on the BCD output operates when the BCD output is
installed.
● The instrument can return to the Measurement mode by pressing the
key even in the halfway of the Check mode.
7−17−1. Operating procedure for the check mode
● When the key is pressed with the load display of “FUNC”, the
display will change as the following arrow marks indicate at every
time the key is pressed. However, every time the key is pressed,
the display will change as the reverse direction of the following arrow
marks.
“FUNC”→“CCAL”→“ACAL”→“LCAL”→“ZERO”→“SPAN”
→“TARE”→”CHEK”→”MONT”→”VCAL”→”VADJ”→”FUNC”
→ “CCAL”→ ・・・（Hereinafter over and over again. ）
To Next Page
