49
Procedures
Press the key.
The display of “ZERO” on the load display
section flashes on and off, and Tare weight
cancellation is entered.
4
Warning ： At the same time, care should
be taken not to apply load variation due to
vibration and so on.
If load variation is applied, zero point
becomes unstable, so there is a possibility
that correct zero can’t be read.
When completed, the indication of load display
shows “END”.
However, when the initial load isn’t entered
within the range of −2.5 mV/V and 2.5 mV/V,
the error code in the right will be shown for
about 2 seconds, then the display on the load
display shows “TARE”, and returns to the step 2.
Error code
TE−L：Zero point −OVER
TE−H：Zero point ＋OVER
Error code
To Next Page
