27
CONTENTS
MANUAL GROUND BALANCE
Ground Balance can be manually adjusted until the
minimum amount of ground signal is present�
1. Press the Settings button to navigate to the Ground
Balance setting�
2. Raise and lower the coil repeatedly over a clear patch of
soil that does not contain any targets�
Listen to the audio response to interpret the result
of the Ground Balance; a low tone indicates that you
should increase the Ground Balance value and a high
tone indicates that you should decrease it�
3. Press the Minus (–) and Plus (+) buttons to manually
change the Ground Balance value until the minimum
amount of ground signal is heard� The Manual Ground
Balance value is shown on the Target ID Display�
TRACKING GROUND BALANCE
When Tracking Ground Balance is active, the detector
continuously adjusts the Ground Balance automatically
during detecting� This ensures that Ground Balance is
always set correctly�
Tracking Ground Balance is the default and
recommended method for Gold* Mode�
Tracking Ground Balance can also be useful when
using Beach Mode 2 underwater at the beach (in
salt water)�
1. Press the Settings button to navigate to the Ground
Balance setting�
2. Press the Accept/Reject button to toggle Tracking
Ground Balance On/Off�
When Tracking Ground Balance is On, the Tracking
Indicator will appear on the LCD, and Ground Balance
will track automatically in the background�
Ground Balance (Continued)
* EQUINOX 900 only
To Next Page
Loading...
