60
CONTENTS
DOCUMENT USAGE RIGHTS
This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4�0 International (CC BY-NC-
ND 4�0) International License� To view a copy of this license, visit: http://creativecommons�org/licenses/by-nc-nd/4�0/
DISCLAIMER
The Minelab metal detector described in this instruction manual has been expressly designed and manufactured as a
quality metal detector and is recommended for treasure and gold detecting in non-hazardous environments� This metal
detector has not been designed for use as a mine detector or as a live munitions detection tool�
MINELAB®, EQUINOX®, Multi-IQ®, EQX06™, EQX11™, and EQX15™ are trademarks of Minelab Electronics Pty� Ltd�
COMPLIANCE
To view product compliance information, navigate to the Noise Cancel setting, then press-and-hold the All Metal button�
Refer to the included Instructions and Safety Information leaflet for further regulatory information�
Factory Reset
The Factory Reset function returns all detector settings,
Search Modes, and Discrimination Patterns to their Factory
Preset state�
1. Ensure the detector is powered Off�
2. Press-and-hold the Power Button until 'FP' appears on
the Target ID Display�
'FP' will appear on the Target ID display
when Factory Presets are restored�
Software Updates
EQUINOX Series detectors contain software
that can be updated via the supplied USB
charging/data transfer cable�
Visit www�minelab�com/support for
up-to-date EQUINOX Software and
installation instructions�
To Next Page
Loading...
