Minerva Classic - Chair Assembly Steps; Attach Chair Back to Seat; Install Chair Arms; Finalize Arm Assembly

3.
 Lay back of chair and seat on
side and insert all 4 large bolts
with washers.
Note: Insert bolt with washer
such that bolt head and washer
are inside chair base.
 Align bolts with holes on dryer
back and tighten to create a
snug fit between chair and back.
Note: Socket wrench (not
included) may be used to further
tighten arm bolts.
4.
 Insert 3 bolts into arm of chair.
The top hole nearest the
"pointed" part of the arms will
not receive a bolt.
 After bolts are inserted, turn arm
over and insert cylindrical
guides.
 Attach arm to chair and tighten
bolts. Repeat with second arm.
5.
 Once arms are attached to chair,
insert plugs so screw heads are
not visible on chair arms.
END OF INSTRUCTIONS