REFERENCE AT A GLANCECONTROLSDRIVING TIPSMOBILITY
51
1 Button for:
> Selecting display
> Setting values
> Confirming selected display or set values
> Calling up computer information 49
2 Calling up Check Control 55
3 Displaying vehicle check 56
4 Initializing the Flat Tire Monitor 60
Resetting the Tire Pressure Monitor 62
5 Setting formats and units of measure, reset-
ting to factory settings 52
6 Adjusting settings
> Confirmation signals when locking and
unlocking the vehicle 20
> Response during unlocking
procedure 19
> Automatic locking 22
> Pathway lighting 67
> Daytime running lamps 68
> Triple turn signal activation 42
7 Setting the time 54
8 Setting the date 55
9 Exiting the menu
Exiting displays
1. Briefly press the button in the turn indicator
lever repeatedly until "HOME" is displayed.
2. Press the button for a longer period.
The display again shows the outside tempera-
ture and the time.
Displays are also exited if no entries are made
for approx. 8 seconds.
Next setting or item of information
1. Within a setting or item of information,
briefly press the button in the turn indicator
lever repeatedly until "NEXT" is displayed.
2. Press the button for a longer period.
The display changes directly to the next setting
or item of information.
Formats and units of
measure
To set the formats and units of measure. The set-
tings are stored for the remote control currently
in use, refer also to Personal Profile on page 18.
PDF Decrypter Trial
Website : http://www.softlay.org
To Next Page
Loading...
