On the front passenger seat
Deactivating airbags
Warning
Active front-seat passenger airbags can in-
jure a child in a child restraint system
when the airbags are activated. There is a
risk of injury. Make sure that the front-
seat passenger airbags are deactivated and
that the PASSENGER AIRBAG OFF indica-
tor light lights up.
Before installing a child restraint system in
the front passenger seat, make sure that the
front, knee and side airbags on the front
passenger side are deactivated.
Deactivate the front-seat passenger airbags
automatically, refer to page 144.
Seat position and height
Before installing a child restraint system,
move the front passenger seat as far back as
possible and adjust its height to the highest
and thus best possible position for the belt
and to offer optimal protection in the event
of an accident.
If the upper anchorage of the safety belt is
located in front of the belt guide of the child
seat, move the front passenger seat care-
fully forward until the best possible belt
guide position is reached.
Child seat security
The rear safety belts and the front passen-
ger safety belt can be permanently locked to
fasten child restraint systems.
Locking the safety belt
1. Pull out the belt strap completely.
2. Secure the child restraint system with
the safety belt.
3. Allow the belt strap to be pulled in and
pull it tight against the child restraint
system. The safety belt is locked.
Unlocking the safety belt
1. Unbuckle the safety belt buckle.
2. Remove the child restraint system.
3. Allow the belt strap to be pulled in com-
pletely.
LATCH child restraint fixing
system
General information
LATCH: Lower Anchors and Tether for Chil-
dren.
Pay attention to the operating and safety in-
formation from the child restraint system
manufacturer when installing and using
LATCH child restraint fixing systems.
Seite 92
CONTROLS Transporting children safely
92
Online Edition for Part no. 01402666575 - VI/19
To Next Page
Loading...
Need help?
General
