Switching the view via the Central
Information Display (CID)
If the rearview camera view is not dis-
played, change the view via the Central In-
formation Display (CID):
"Rear view camera"
The rearview camera image is displayed.
Display on the Control Display
Functional requirements
– The rearview camera is switched on.
– The trunk lid is fully closed.
– Keep the recording range of the camera
clear.
Protruding cargo or carrier systems that
are not connected to a trailer power
socket can lead to malfunctions.
Activating assistance functions
More than one assistance function can be
active at the same time.
The zoom function for trailer operation can
only be activated separately.
– Parking aid lines
"Parking aid lines"
Lanes and turning radius lines are indi-
cated.
– Obstacle marking
"Obstacle marking"
Obstacles are marked, depending on the
vehicle equipment.
– Trailer hitch
"Trailer hitch - zoom"
A zoomed image of the trailer hitch is
shown.
Pathway lines
Pathway lines can be superimposed on the
image of the rearview camera.
Pathway lines help you to estimate the
space required when parking and maneu-
vering on level roads.
Pathway lines depend on the current steer-
ing angle and are continuously adjusted to
the steering wheel movements.
Turning radius lines
Turning radius lines can be superimposed
on the image of the rearview camera.
Turning radius lines show the course of the
smallest possible turning radius on a level
road.
Only one turning radius line is displayed af-
ter the steering wheel is turned past a cer-
tain angle.
Seite 171
Driving comfort CONTROLS
171
Online Edition for Part no. 01405A02757 - II/20
To Next Page
Loading...
