Communications At a glanceControlsDriving tipsEntertainment
91
NavigationMobilityReference
Installing cup holder
1. Lock base plate in place if necessary, refer to
Sliding and locking.
2. Pull the lever 6 up to unlock the mounts.
3. First insert the cup holder into the front
mounts 4 and then snap it into the rear
mounts 5.
Make sure that the lever 6 is situated
opposite the mount 4.<
Clothes hooks
There are clothes hooks on the grab handles in
the rear passenger compartment.
Items of clothing hung from the hooks
must not obstruct the driver's view. Do not
hang heavy objects from the hooks; otherwise,
they could endanger the car's occupants, e.g. in
case of heavy braking or sudden swerving.<
In the cargo area
Depending on your vehicle's equipment, you
have the following storage options:
> Storage compartment under the flat load
floor
*
> Bag holder on the support for the cargo area
cover
Cup holders and
ashtray*
Cup holders*
Use lightweight, nonbreakable containers
and do not transport hot beverages. Oth-
erwise, there is an increased risk of injury in the
event of an accident.<
Do not push unsuitable containers forcibly
into the cup holder. Otherwise, you may
damage it.<
Additional cup holders can be attached to the
Center Rail in the rear passenger compartment.
Ashtray*
The ashtray is located in one of the cup holders
in the center console.
Emptying
Remove the entire ashtray.
Lighter
With the engine running or the ignition switched
on, press in the cigarette lighter.
The lighter can be pulled out as soon as it pops
back out.
ba8_r60.book Seite 91 Mittwoch, 6. Oktober 2010 9:27 09
Online Edition for Part no. 01 40 2 606 303 - © 10/10 BMW AG
To Next Page
Loading...
