Resetting average values
Press and hold the button on the turn indi-
cator lever.
Engine temperature display
Displays current engine temperature from a
combination of coolant and engine oil tem-
perature. If the engine is at its optimum op-
erating temperature, the display is in the
centre position.
If the engine oil or coolant and therefore
the engine become too hot, a Check Control
message is displayed as well.
Checking the coolant level, see page 300.
Speed Limit Info
Speed Limit Info shows the currently detec-
ted speed limit in the instrument cluster.
On-board computer on the Control
Display
Principle
The on-board computer shows various vehi-
cle-related data, such as average values, on
the Control Display.
General
Two types of on-board computer are avail-
able on the Control Display:
– "On-board computer": average values
such as the fuel consumption are dis-
played. The values can be reset individu-
ally.
– "Trip computer": values provide an over-
view of a particular route, and can be re-
set as often as required.
Call up on-board computer or journey
computer
Using the on-board monitor:
1. "My MINI"
2. "Driving information"
3. "On-board computer" or "Trip computer"
Resetting the on-board computer
Using the on-board monitor:
1. "My MINI"
2. "Driving information"
3. "On-board computer"
4. "Consumption" or "Speed"
5. "OK"
Resetting the trip computer
Using the on-board monitor:
1. "My MINI"
2. "Driving information"
3. "Trip computer"
4. If necessary, tilt the Controller to the
left.
– "Reset": all values are reset.
– "Reset automatically": all values
are reset if the vehicle is at a stand-
still for approximately 4 hours.
5. If necessary, "OK"
Seite 137
Displays CONTROLS
137
Online Edition for Part no. 01402988211 - II/18
To Next Page
Loading...
