Removing
Only remove the head restraint if no-one is
intending to sit on the seat in question.
1. Fold down the corresponding rear back-
rest, see page 213.
2. Pull up the head restraint until resist-
ance is felt.
3. Press the button, arrow 1, and pull the
head restraint fully out.
Installing
Proceed in the reverse order to install the
head restraint.
Memory function
Principle
The memory function enables the following
settings to be stored and retrieved when re-
quired:
– Seat position.
– Exterior mirror position.
General
Two memory slots can be assigned with dif-
ferent settings.
The lumbar support setting is not saved.
Safety notes
WARNING
There is a risk of entrapment when the
seats are being moved. There is a danger
of injury or damage to property. Before
making any adjustment, make sure that
the area of movement of the seat is kept
clear.
WARNING
Using the memory function while driving
may cause the seat to move unexpectedly.
You could lose control of the vehicle.
There is a danger of accidents. Only call up
the memory function when the vehicle is
at standstill.
Overview
Saving
1. Switch on the ignition.
2. Set the desired position.
3.
Press the button. The LED in
button is illuminated.
4. Press the desired button 1 or 2 while the
LED is illuminated. The LED is extin-
guished.
Seite 87
Seats, mirrors and steering wheel CONTROLS
87
Online Edition for Part no. 01402988211 - II/18
To Next Page
Loading...
