Engage selector lever position P only when
the vehicle is stationary.
Before exiting the vehicle, make sure that
selector lever position P is set. Otherwise,
the vehicle may begin to move.
Engaging selector lever positions:
with a latching selector lever
General information
To prevent the vehicle from creeping after
you select a drive mode, maintain pressure
on the brake pedal until you are ready to
start.
Functional requirements
The selector lever can only be taken out of
selector lever position P if the ignition is on
or the engine is running.
Engaging selector lever position D, N,
R, or P
With the vehicle stationary, depress the
brake pedal before shifting out of selector
lever position P or N; otherwise, the shift
block will not be deactivated and the shift
command will not be executed.
A selector lever lock prevents the following
faulty operation:
– Unintentional shifting into selector
lever position P or R.
– Unintentional shifting from selector
lever position P into another selector
lever position.
1. To release the selector lever lock: with
the brake pedal depressed, press the
button on the front of the selector lever.
2. Move the selector lever into the desired
position.
Rolling or pushing the vehicle
General information
In some situations, the vehicle is to roll
without its own power for a short distance,
for instance in a vehicle wash, or be pushed.
Engaging selector lever position N:
with a latching selector lever
1. Switch on drive-ready state.
2. If necessary, release the parking brake.
3. Depress the brake pedal.
4. Touch the selector lever lock and en-
gage selector lever position N.
5. Release brake.
Seite 137
Driving CONTROLS
137
Online Edition for Part no. 01402628632 - VI/19
To Next Page
Loading...
