On the road
Driving
Activate/deactivate drive-ready
state
Ignition on/off
– On: press the Start/Stop
button.
Most of the indicator/
warning lights light up for
a varied length of time.
– Off: press the Start/Stop button again.
All indicator lights go out.
– Radio-ready state: when the ignition is
switched off, press the ON/OFF button
on the radio or when the engine is run-
ning, press the Start/Stop button.
Some electronic systems/power con-
sumers remain ready for operation.
Activate/deactivate drive-ready state
Activating
1. Close the driver's door.
2. Depress the brake pedal.
3. Press the Start/Stop button.
The drive-ready state is active: electric driv-
ing is possible, or the engine can be started.
Deactivating
1. Engage selector lever position P with
the vehicle stopped.
2. Press the Start/Stop button.
3. Set the parking brake, if needed.
Auto Start/Stop function
The Auto Start/Stop function helps save
fuel. The system switches off the combus-
tion engine when conditions for electric
driving have been met. The ignition re-
mains switched on.
READY appears on the tachometer. If nec-
essary, the combustion engine starts auto-
matically.
Parking brake
Setting
Pull the switch.
The LED and indicator light light up.
Releasing
Steptronic transmission: press the
switch while the brake is pressed or
selector lever position P is set.
The LED and indicator light go out.
The parking brake is released.
Steptronic transmission
Selector lever positions
Parking position P.
R is reverse.
Neutral N.
Drive mode D.
Engage selector lever position P or R only
when the vehicle is stationary.
To prevent the vehicle from creeping after
you select a drive mode or reverse, maintain
pressure on the brake pedal until you are
ready to start.
Seite 29
On the road QUICK REFERENCE
29
Online Edition for Part no. 01402628632 - VI/19
To Next Page
Loading...
