| 27 |
Note
Warning
▶ Grounding is required to prevent electric shocks. Check the availability of circuit breaker.
- Contact the sales store or service center for further details.
▶ If the power outlet has no grounding terminal:
- Grounding must apply for the safe use of washer.
- Grounding is performed by the service center engineers or qualified personnel only.
- Contact your nearby service center for details.
▶ Grounding is prohibited in the following locations.
- Gas pipe (It has the risk of explosion or fire)
- Phone wire or lightning rod (It is risky when struck by lightning)
- Water pipe (Many water pipes are made of plastic materials)
If a power cord is broken, you should contact the sales store or service
center as a special tool is required.
Contact the service center to relocate the installation.
(Additional charge applies)
Exchange of Power Cord
Relocation
- Organize inlet and drain hoses and power cord
with molding and hose guide.
15. Organize inlet and drain hoses and power cord
- Connect 4 nuts and bolts above and below after
mounting the body.
16. Mount the body
※ Wipe the attachment area clean with a dry cloth and
then attach the molding and hose guides tightly.
※
Check whether any cleavages exist on both sides.
Wall Type Depth of Hole Bit diameter of hammer drill Bit diameter of tile hole
Concrete 45mm
Ø 13mm
-
Tile
Distance between tile and
retaining wall + 45mm
Ø 14mm
미니_DWD-M221MB(영)_호주향_1도.indd 27 2017-07-04 오후 4:46:37
To Next Page
Loading...