EasyManua.ls Logo

Mini HARDTOP 2 DOOR - Page 103

Mini HARDTOP 2 DOOR
328 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Additional Auto Start/Stop
function
Depending on the vehicle equipment and
country-specific version, the vehicle fea-
tures a variety of sensors for assessing the
traffic situation. The Auto Start/Stop func-
tion uses this information to adapt to vari-
ous traffic situations in a proactive manner.
For instance, this applies to the following
situations:
When a situation is detected in which
the stopping time is expected to be very
short, the engine is not switched off au-
tomatically. A message appears on the
Control Display, depending on the situa-
tion.
When a situation is detected in which
the vehicle needs to drive off immedi-
ately, the engine is started automati-
cally.
The function may be restricted if the navi-
gation data is invalid, outdated or not avail-
able, for example.
Switching the system on/off
Using the button
Press the button.
LED comes on: auto Start/Stop function
is deactivated.
The engine is started during an auto-
matic engine stop.
The engine can only be stopped or
started via the Start/Stop button.
LED goes out: auto Start/Stop function
is activated.
Switching off the vehicle during an
automatic engine stop
During an automatic engine stop, the vehi-
cle can be switched off permanently, for in-
stance when leaving it.
Steptronic transmission:
1. Engage selector lever position P.
2. Press the Start/Stop button. The ignition
is switched off. The Auto Start/Stop
function is deactivated.
3. Set the parking brake.
Manual transmission:
1. Press the Start/Stop button. The ignition
is switched off. The Auto Start/Stop
function is deactivated.
2. Shift into first gear or reverse.
3. Set the parking brake.
Engine start as usual via Start/Stop button.
Automatic deactivation
In certain situations, the Auto Start/Stop
function is deactivated automatically for
safety reasons, for instance if no driver is
detected.
Malfunction
The Auto Start/Stop function no longer
switches off the engine automatically. A
Check Control message is displayed. It is
possible to continue driving. Have the sys-
tem checked by a dealer's service center or
another qualified service center or repair
shop.
Seite 103
Driving CONTROLS
103
Online Edition for Part no. 01405A1E4E3 - II/20

Related product manuals